Edge ED71200 User Manual download pdf (Page 4)

Mounting the Cable Cubby in the Table

Mount the Cable Cubby ﬂush with the table.

CAUTION: The Cable Cubby edges are sharp. Exercise care to prevent scarring or damaging the skin and furniture.

Step 2 — Install the Modules.

Determine where the connectivity modules and power module will be installed in the Cable Cubby. The modules may be installed

on the left or right side of the enclosure and at various heights.

NOTE: Ensure that there is enough room above the modules for the Cable Cubby lid to close completely.

WARNING: Electric shock hazard. To ensure proper electrical grounding,

use the provided #6-32 mounting screws with the star washers.

Remove the plastic strips and

lm on the surface of the

Cable Cubby.

Ensure that the

side clamps are

seated against the

enclosure.

Lower the Cable Cubby into the hole to test the t.

If necessary, carefully enlarge the opening.

Secure the modules using four of the provided mounting screws and star washers.

Insert the modules

into the Cable Cubby.